The combined stainless steel water tank is composed of standard modules and stainless steel plates punched out. According to the design parameters of different three-dimensional structures, different thickness modules are used for welding assembly in the factory or on site.
The stamping module of the water tank is divided into 1000 * 1000, 1000 * 500 and 500 * 500 standard blocks.
The four sides of a combined water tank and roof can be assembled into modules, the focus here to introduce the next selection of tank bottom plate, steel structure and material, has a great influence on the deformation of these factors from the water tank, so the design and installation of water tank, should first ensure the stability and overall strength of the foundation.
1. channel steel:
The general practice of channel base of transverse and longitudinal channel spacing of 1m, the whole rigid steel frame slot and endurance is poor, and I, the transverse and longitudinal channel spacing of 0.5m, the full weld connection, to ensure a solid foundation of high strength.
2. floor:
General practice floor adopts the folding board, placed in the reverse channel, the channel spacing of 1m, in the bearing state (filled with water) under the floor edge folding floor due to compression, the edge is in an unstable state, thus the outward bending deformation caused by uneven floor, the deformation of the whole water tank. Our company uses molded flat plate, placed in the 0.5 spacing channel above, stable and non deformation.
Stainless steel water tank internal structure -- Shanghai stainless steel water tank factory