Stainless steel water tank appearance
1. water tank surface should be clean, no welding marks, no kerosene, test oil after the remaining black print.
2. the weld seam is smooth and the cross weld misalignment is not greater than 3mm.
3. no distortion of the tank, the slope is not greater than 1 degrees, do not meet the requirements, the scene rectification.
4. welding needs to be smooth and beautiful. Cross weld deviation shall not exceed 3mm.
5. the top of the living water tank is not made of glass glue. (including the upper part of the box pump integrated pump house)
6. manholes need locking device
Stainless steel water tank, escalator
1. the height of the ladder is 200mm higher than that of the water tank.
2. bend. The top of the ladder is folded into the 200mm at the inner end of the water tank and connected with the roof of the water tank.
The distance between 3. steps is 350mm. The width of the escalator is 300mm.
The 4. ladder is made of 6 pivots, each of which has a length of 150mm, and is fully welded on the side plate of the water tank (higher than 2m above the water tank, and the fulcrum is appropriately increased)
Stainless steel water tank vent hole
The vent hole specification is DN100 stainless steel elbow. The front end air holes need to add special insect net cap. Connect the tank end to full weld. Vent holes must be installed for each tank, such as customer's no requirement.
Stainless steel water tank water pipe interface
Accessories include water intake, water outlet, overflow port, sewage outlet, float ball valve, level gauge, and other openings required by the project. All openings are divided into two broad categories. One is a flange and the other is a silk mouth. In case of construction, the customer does not specify the flange or wire. All DN50 (including DN50) for the silk mouth, DN65 (including DN65) above all flange. Flange welding must be flat water suspension. The two holes on the top of the flange are horizontal. All the water pipe interface is only responsible from the tank to the first flange / wire stop, excluding the float valve, liquid level gauge and other engineering parts.
Stainless steel water tank inner main pull bar
The main function of the main pull is to prevent tank deformation, the thickness is usually near the bottom of the lateral plate thickness, based on specifications for 4cm*4cm. The welding space is generally 1000mm, a large water tank, especially the height of more than 3 meters. The spacing should be 500mm 1, and the connections must be fully welded.
Stainless steel water tank diagonal reinforcement
The main function of the cable-stayed is to share the pulling force of the main tension bar. The water tank plate is further stabilized and cut into the length of 500mm, and is connected between the water tank and the main pull. The formation of claw type, conventional size 4cm * 1cm thickness to side thickness near the top of the base, the connection must be full of welding processing.
Stainless steel tank column
The main role is to prevent the roof collapse in a supporting role, deformation. Generally use 4cm * 4cm specifications, the thickness of the top plate thickness as the benchmark.